Кабель MC-AP

MC-AP Cable

Tools

H2.0 hex cable

Tweezers

Preparation

Power off the printer, and eject the SD card.

Disassembly

Step 1 - Remove the rear panel

Refer to the relevant content of the Rear panel to remove the rear panel.

Step 2 - Loosen the AP board

Refer to the relevant content of the AP board to remove the screen and front cover, and remove the AP board from the beam to expose the MC-AP connector.

Step 3 - Disconnect the cables

Disconnect the MC-AP cable from the connectors on the AP board and MC board respectively.

Step 4 - Remove the MC-AP cable

Remove the fixing tapes, release the cable from the cable slot, and remove the MC-AP cable.

Assembly

Step 1 - Pass through the cable

Pass the MC-AP cable through the cable holes and press it into the cable slot.

Step 2 - Connect the MC-AP cable

Connect the two ends of the cable to the corresponding connectors on the AP board and the MC board respectively.

Step 3 - Install the AP board

Refer to the relevant content of the AP board to install the AP board and screen.

Step 4 - Sort out the cable

Fix the MC-AP  cable along the beam with tapes.

Step 5 - Install the rear panel

Refer to the relevant content of the Rear panel to install the rear panel.

How to verify

Power on the printer, and run the device calibration process. If the calibration passes, the operation is successful.