Filament Cutter Stopper
The filament cutter stopper assemblies are installed on the right sides inside the printer chamber. They are used to support the cutter, allowing it to cut the filament and complete functions such as material changing and unloading.
Filament Cutter Stopper :
Filament Cutter Stopper * 1
BT2.6x8 * 2
M2.5x5 * 2
When to Replace
- Filament cutter stopper is damaged.
Required Tools and Materials
New filament cutter stopper
H2.0 Allen key
Specifications and quantities of screws involved in replacing the H2S filament cutter stopper (it is recommended to keep the removed screws properly to avoid loss):
| Specification | Image | Use | Position | Quantity | |
|---|---|---|---|---|---|
| M2x5 | Fix the filament cutter stopper - (marked by the green square) | image | 4 |
Safety Warning
IMPORTANT!
It's crucial to power off the printer before conducting any maintenance work, including work on the printer's electronics and tool head wires. Performing tasks with the printer on can result in a short circuit, leading to electronic damage and safety hazards.
During maintenance or troubleshooting, you may need to disassemble parts, including the hotend. This exposes wires and electrical components that could short circuit if they contact each other, other metal, or electronic components while the printer is still on. This can result in damage to the printer's electronics and additional issues.
Therefore, it's crucial to turn off the printer and disconnect it from the power source before conducting any maintenance. This prevents short circuits or damage to the printer's electronics, ensuring safe and effective maintenance. По любым вопросам или сомнениям, связанным с этим руководством, мы рекомендуем отправить запрос в техподдержку.
Remove the Filament Cutter Stopper
You can use an H2.0 Allen key to remove the four fixing screws of the filament cutter stopper (Red circle marking: BT2.6x8; Green box marking: M2.5x5).
Install the Filament Cutter Stopper
Before installing the filament cutter stopper, move the X-axis to the front (close to the front glass door).
Align the filament cutter stopper with the screw holes on the printer, then use an H2.0 Allen key to tighten the four fixing screws (Red circle marking: BT2.6x8; Green box marking: M2.5x5).
Verify the Functionality
Check that the filament cutter stopper is stable and does not wobble, ensuring it can properly support the cutter.