Packing Tips
Proper packaging is the most effective way to avoid shipping damage, as it ensures the safety of your AMS HT and minimizes unnecessary economic losses.
To ensure safe transport, please use the original packaging whenever possible. If the original packaging material are no longer available, it is recommended to use suitable alternative packaging materials.
To ensure your equipment remains secure during transit, we kindly remind you to:
Check that all screws are tightened, to secure internal components.
Check that all cushioning foam is properly placed, to fully protect the equipment.
Operation Steps
Step 1: Remove PTFE Tube
Press the PTFE tube release button from the back of the AMS HT to unlock the fitting, then pull the PTFE tube out.
image | image |
Step 2: Disconnect Bambu Bus Cable 6-Pin and Power Cord
Press the bottom of the cable connector to disconnect Bambu bus cable 6-pin. Then, disconnect the power cord.
image | image |
Wrap up the Bambu bus cable 6-pin and power cord. Then, place the PTFE tubes (263mm × 2 + 900mm × 1) into packaging bag.
image | image |
Place the packaging bag inside AMS HT. Then close the top lid and put AMS HT in the protective bag.
image | image |
Step 3: Packing
- Place AMS HT into cardboard box, making sure it is aligned with the shape of the bottom foam padding.
image | image |
- Secure Bambu bus cable 6-pin, power cord, and spare desiccant (if applicable) into the recesses of the bottom foam padding.
- Then, place the instruction manual on top of AMS HT.
- Then, Fit the upper foam protective cover over AMS HT.
image | image |
- Finally, secure the cardboard box with tape.